PartsOrder

Mike needs:

• 9V voltage regulator (5) - jameco doesn't seem to have them. [Digi-key does.]
• Li 2016 coin cells (4) [jameco part number] (They go for as low as $.50 elsewhere, check http://www.froogle.com - [one source] but shipping probably costs too...)
  • (They're $0.45/1 at Digi-key. CR2032 is the same price. Twice the height, ~2.5x capacity. -m.)
• Photoresistors. 10? Digi-key has them for cheaper. [one kind.]

Raj needs:

• flux
• angle cutters

mang needs:

• bench power supply
• IDC cables (10-pin) - thanks dodger!
• IDC cable headers (10-pin, 6-pin)
• single row 11 pin headers (for RF modules)
• (more) terminal blocks
• small slide switches (on - off - strobe)
• DC/DC converters (MAX1663 or something)
• surface mount to SIP thingies (surfboard)
• solid state relays (photomosfet)
• capacitor assortment

• C and D cell battery holders (9V snap)
• hard plastic 9V battery snaps

• large project boxes for AMB el sequencers - Done!
• CAT5 breakout connectors (telephone stylee)
• 12V battery clips for charger (Kragen)

• NPN transistors
• MOSFETs (IRL320)

• serial-input parallel-output shift registers (e.g. 74HC409)

• IC remover
• IC pin straightener
• 28-pin sockets (nice ones)
• random socket assortment
• 2 position .2" center terminal blocks
• 8 position .2" center terminal blocks

• SS copper clad boards
• adapter so jeweler drills can go in Dremel
• PCB drill bits
• Dremel drill press
• stepper motors

• DIP clip (tiny programming)

AVR stuff:

• 6-pin IDC header for ISP
• AVR 6-pin ISP programmer adapter
• AVR butterflies

• ATMega16
• low profile 16MHz crystals
  • trimmer caps for this xtal

SMT stuff:

• caps for tiny26 board
• 0805 resistors for LEDs
• 1206 resistors
• 1206 caps
• 1206 LEDs
• 8-pin SOIC regulators
• SMT RGB LEDs

• water-soluable solder paste
• plunger
• syringe

• vacu-pickup tool? - thanks Mike!
• heat pen for manual work(?)
• hot-air rework station(?)

• Holtek encoder/decoder chips (HT-640/HT-648L)

Video stuff:

• long S-Video cable
• S-Video dongle for Inspiron
• BNC video terminators
• video transmitter?
• big ass VGA cable
• long Firewire cable

Audio:

• TDA2822M - 8-pin DIP audio amp, as used in Budda Tone (aka Pocket Eno)

This stuff:
1  	4  	A25915-ND  	CONN HOUSING 6POS .100 DUAL ROW  	    	0  	0.63000  	$2.52
2 	20 	A28328-ND 	CONN SOCKET 22-26AWG 15AU CRIMP 	  	0 	0.07200 	$1.44
3 	20 	311-1.00KFCT-ND 	RES 1.00K OHM 1/4W 1% 1206 SMD 	  	0 	0.08800 	$1.76
4 	10 	311-150ECT-ND 	RES 150 OHM 1/4W 5% 1206 SMD 	  	0 	0.07800 	$0.78

goldmine-elec.com stuff
  	G15293  	 	 Brilliant Green SMD LED by HP (Pkg of 10)  	$0.99  	   	$1.98
	G13706 		Blinding Output Blue SMD LED 	$0.42 	  	$42.00
	G15698 		5.5" x 12" Scissor Cut SS Copper Clad 	$1.75 	  	$3.50
	G15665 		Blue Single Sided 4" x 6" Copper Clad 	$3.49 	  	$13.96
	G2624 		3" x 6" Copper Clad .021" Thick 	$0.55 	  	$2.20
	G2636 		6" x 12" Copper Clad .021" Thick 	$2.15 	  	$4.30
	W22001 		Dual Cat 5 Connector (Pkg of 4) 	$1.00 	  	$2.00
	G13512 		5.5mm DC Power Jack w/ NC Switch (Pkg of 2) 	$1.00 	  	$4.00
	G15664 		Unique Green Neon Lamp (Pkg of 2) 	$1.00 	  	$5.00
	G14781 		KP4M4-029 12VDC Stepper Motor 	$2.95 	  	$5.90

Digikey: Aavid Thermalloy Slide-on heatsink HS179-ND 3A H-Bridge LMD18200T

Interesting parts (not ordering yet):

• [1A boost/flyback converter]

Jameco Order

Digikey Order

Mouser Order